EOS Wireless

User guide

Package Contents

01.  LED


02.  DOUBLE LITHIUM BATTERY


03. BATTERY CHARGER

04.   USB CABLE


05.  POWER SUPPLY


06. ELECTRICAL SOCKET ADAPTOR KIT 

07.  UNIVERSAL ADAPTER


08.  UV FILTER


09. ALLEN KEY AND SCREWDRIVER SET

 CAUTION 
 

Follow all steps in the sequence indicated for the optimum correct result.

BATTERIES
 

It is recommended that you recharge both batteries included in the package before using EOS Wireless for the first time.

01.

CHARGING THE BATTERIES

THE CHARGING TIME OF EITHER ONE BATTERY OR TWO BATTERIES (SIMULTANEOUSLY): 90 MINUTES

Hook the batteries to the charger. Connect the charger to the power supply via the USB cable. Connect the power supply to the adapter suitable for your power socket.

The charger is equipped with two slots for simultaneous charging of the two batteries included in the package. (The charging time of 90 minutes remains unchanged whether 1 or 2 batteries are connected to the charger).

While charging, the charge status indicators flash (A) and all remain lit when fully charged (B).

02.

ATTACH THE BATTERIES TO THE LED

PRESS RELEASE

Make sure that the batteries are correctly aligned with the positive and negative contacts.
Attach the battery to the LED by exerting slight pressure.

03.

BATTERY CHARGE STATUS INDICATION

BY CONNECTION TO THE LED

Once the battery is attached to the LED, the charge indicators will light up for 4 seconds indicating the charge level.

04.

HOW TO READ

THE BATTERY CHARGE LEVEL

To view the charge status, see points 3. and 6. of this section.

(ATTENTION: the charge status signal remains active for 4 seconds).

05.

LOW BATTERY INDICATION WHILE IN USE

WITH LED ATTACHED TO THE MAGNIFYING SYSTEM

If the battery charge status drops below the 10% threshold while using the LED, the user is warned through an intermittent variation of the light intensity.
(The remaining autonomy will be about 5 minutes).

ATTACHMENT TO THE MAGNIFYING SYSTEM
 

Only connect the device to the magnifying system after connecting the battery to the LED.

CAUTION
 

Avoid replacing the low battery by keeping the LED device attached to the magnifying system.

POWER ON AND OFF
 

Once the battery is connected to the LED, it is necessary to wait 3 seconds before proceeding with switching on
(the lock is necessary to prevent the user from experiencing glare while reading the battery level)

ON/OFF Touch control

ON/OFF Temple Touch control

ON/OFF Aseptic control

CAUTION
 

Avoid turning the device on and off too quickly (less than 3 seconds) as the device may go into “security lock-out”.

UV FILTER

UV FILTER
HOOK

While using light pressure, hook the UV filter (included in the package) on the front of the LED.

CAUTION
 

To avoid the risk of glare, do not use the lit LED device when it is not attached to the magnifying system as it could go into “safety-lock”.